robbert Posted November 8, 2014 Share Posted November 8, 2014 I'm a noob to all this, please bear with me. So, I have a tomy dispenser which I read is supposed to support prize sizes of 2 inches (depending where I read the info, that's 49 mm or 51 mm or 52 mm) But, when I test it with a ball with a diameter of around 44mm or 45mm, it gets stuck in the back of the prize door more than half the time! Are there adjustments I can make, or do I have the size wrong? Link to comment Share on other sites More sharing options...
rodney69 Posted November 9, 2014 Share Posted November 9, 2014 45mm is about 1 and 3/4". I'm not familiar with Tommy stuff though. Make sure the wheel is lined up with the whole too. Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.