Jump to content

Problem with new Greenwald V5 coin slide mech


tevans62

Recommended Posts

Got a new $1 Greenwald V5 coin slide mech in and it tends to stick, gets tougher to push in, near the end of slide. I have to push harder to get the 4 quarters to slide all the way thru and drop. I took it out of machine and sprayed some brake cleaning fluid in it. Ran a bunch of quarters thru it and it seemed to loosen up some. Do I need to loosen some screw or check something else to get this to slide smoothly? Any help would be much appreciated!!

Link to comment
Share on other sites

For take a couple pictures of it so if you have problems putting it back together afterwards, you can refer back to photos. Unhook 2 long springs, unscrew 2screws on top towards the end, clean it out, it is most likely full of toothpicks, paper or a straw

Link to comment
Share on other sites

For take a couple pictures of it so if you have problems putting it back together afterwards, you can refer back to photos. Unhook 2 long springs, unscrew 2screws on top towards the end, clean it out, it is most likely full of toothpicks, paper or a straw

It's brand new and hasn't even been used yet....

Link to comment
Share on other sites

Archived

This topic is now archived and is closed to further replies.

×
×
  • Create New...