Chard Posted April 17, 2017 Share Posted April 17, 2017 Henan Mei 7512 develop some sort of electrical problem in this machine last week. I think I was a bad low level tube sensor. Every time I went out to check the machine it would give me an error saying the B tube was empty I would reset the machine and it would work fine for a day or two and then have another problem. I replaced the coin mech last week and just got a call that machine is not giving proper change.Has anyone developed strange problems with the Vendors Exchange kits? Sent from my SM-G900V using Tapatalk Link to comment Share on other sites More sharing options...
AngryChris Posted April 18, 2017 Share Posted April 18, 2017 I think the problem is with the coin mech. I had the exact same problem in an AP 7600 with a UCB and a 7512. Link to comment Share on other sites More sharing options...
Chard Posted April 29, 2017 Author Share Posted April 29, 2017 Found the problem. The 9302gx doesn't align properly with the coin chute. The back hangs about a quarter inch outside the chuteI notice this with some models we upgrade with inone or ucb kits. The usi 3014a won't fit many mdb mech when upgraded without modification. Sent from my SM-G900V using Tapatalk Link to comment Share on other sites More sharing options...
AngryChris Posted April 29, 2017 Share Posted April 29, 2017 I upgraded a 3014 and the only issue I had was that the MDB harness from the validator wasn't long enough to reach the harnesd coming outb of the board. I'm not sure, but I think the inone board is supposed to have a longer harness for the 301x. Maybe they didn't give you the proper length harness. Link to comment Share on other sites More sharing options...
AngryChris Posted April 29, 2017 Share Posted April 29, 2017 Edit: I may have had to order an extender harness. It was probably over 2 years ago. Link to comment Share on other sites More sharing options...
Chard Posted April 29, 2017 Author Share Posted April 29, 2017 I've had that same problem as problem wellSent from my SM-G900V using Tapatalk Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.