Sodaman32 Posted May 28, 2017 Share Posted May 28, 2017 I have a DN501E that I can't vend without putting money in it. I know there has to be a way to do it. Im sure there is a very simple answer. I have a DN440 and I can just press the lever on the motor and vend any time I want...but not on the 501E. Any help would be appreciated. Link to comment Share on other sites More sharing options...
Chard Posted May 28, 2017 Share Posted May 28, 2017 Do a motor test through the menu on the control board. The directions are usually on the inside of the door panelSent from my SM-G920T using Tapatalk Link to comment Share on other sites More sharing options...
AngryChris Posted May 28, 2017 Share Posted May 28, 2017 If you just want it to free vend, you should be able to set the prices to zero. For an SIID board, press the mode switch, then hold the first and second selection buttons for a couple seconds simultaneously. The machine should say or have said Hd. Now hold those buttons again to scroll to s-p and let go. Once there, hold the selection that you want to change prices on. It will go up or down. If it's going the wrong way, let go and press again. It should go the other way. I know there is a way to set all prices but I don't remember. Link to comment Share on other sites More sharing options...
lacanteen Posted May 28, 2017 Share Posted May 28, 2017 If you just want to do a quick test, hold the motor switch down then pull the door switch. Link to comment Share on other sites More sharing options...
Sodaman32 Posted May 29, 2017 Author Share Posted May 29, 2017 What I am running into is not being able to vend a selection if Im working on it, or a customer comes up while I have it open and I want to get them one from the bottom (Coldest) I have pulled out the service button and hit the switch and couldn't get them to turn. When I changed the shims to cans I had to spend like ten bucks lol Link to comment Share on other sites More sharing options...
packetloss404 Posted May 29, 2017 Share Posted May 29, 2017 I just picked up a Dixie Narco D DNCB 501R/S 11-8, which from my research appears to be a 501T, but branded specific for Dr. Pepper. It is not the 501E as it will not vend bottles. Sound right? How about when you push the service mode button, nothing happens? The digital display stays with SO on the far most right side. It acts like it completely ignores when I push the red service mode button? Is it a possible Controller Board failure? Link to comment Share on other sites More sharing options...
lacanteen Posted May 29, 2017 Share Posted May 29, 2017 11 hours ago, Sodaman32 said: What I am running into is not being able to vend a selection if Im working on it, or a customer comes up while I have it open and I want to get them one from the bottom (Coldest) I have pulled out the service button and hit the switch and couldn't get them to turn. When I changed the shims to cans I had to spend like ten bucks lol Press & hold motor switch, then pull door switch. It'll take a few seconds but the motor will run Link to comment Share on other sites More sharing options...
Sodaman32 Posted May 30, 2017 Author Share Posted May 30, 2017 Thanks Everyone for Helping Out!!! I got it by obviously pressing the switch and then pulling out the service button!!! Learning!! Link to comment Share on other sites More sharing options...
AZVendor Posted May 30, 2017 Share Posted May 30, 2017 Then you can't be Sodaman32 yet, just Sodaman....unless you drink a lot of it. Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.