Sgolembiewski0903 Posted June 14, 2017 Share Posted June 14, 2017 Row E isn't vending and it just tells me to make another selection. It was working before I serviced it today. I wriggled some connections but that didn't help. Sent from my XT1254 using Tapatalk Link to comment Share on other sites More sharing options...
Sgolembiewski0903 Posted June 14, 2017 Author Share Posted June 14, 2017 Not sure if this moght have fell off??Sent from my XT1254 using Tapatalk Link to comment Share on other sites More sharing options...
Sgolembiewski0903 Posted June 14, 2017 Author Share Posted June 14, 2017 At first is was just e1, but then when i opened it up it became all e row motorsSent from my XT1254 using Tapatalk Link to comment Share on other sites More sharing options...
AngryChris Posted June 14, 2017 Share Posted June 14, 2017 I don't know what that harness is for. Check the contacts on the back of the tray. They could have some corrosion on them. A wire brush or something that will take grime off is good. Also make sure no motor wire is disconnected as I believe they are all daisy chained. If a wire is loose or damaged, it will likely be at one end or the other end of the tray. Link to comment Share on other sites More sharing options...
lacanteen Posted June 14, 2017 Share Posted June 14, 2017 That machine has an In-One board. That connector is only for 110 VAC dumb mech and is not used with MDB. Enter service mode, scroll down to diagnostic menu, enter, down to motor test, enter, down to entire tray, enter. You may have closed the door with the tray out, or you may have been in service mode and had the tray out when service mode timed out. Link to comment Share on other sites More sharing options...
Sgolembiewski0903 Posted June 18, 2017 Author Share Posted June 18, 2017 I think something is just very insensitive, did get it working, thanks for your posts! Link to comment Share on other sites More sharing options...
lacanteen Posted June 18, 2017 Share Posted June 18, 2017 14 hours ago, Sgolembiewski0903 said: I think something is just very insensitive, did get it working, thanks for your posts! I have known 6600s to be a bit aloof, at times, but never insensitive. Link to comment Share on other sites More sharing options...
matthew0582 Posted June 18, 2017 Share Posted June 18, 2017 re configure the motors and see if that tray works again Link to comment Share on other sites More sharing options...
Sgolembiewski0903 Posted June 20, 2017 Author Share Posted June 20, 2017 On 6/18/2017 at 4:52 PM, matthew0582 said: re configure the motors and see if that tray works again Noob question, what does it mean to reconfigure a motor? Link to comment Share on other sites More sharing options...
lacanteen Posted June 20, 2017 Share Posted June 20, 2017 <service mode> => <configuration menu> => <configure motors> Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.