Snackpods Posted June 30, 2017 Share Posted June 30, 2017 I have a royal pepsi machine that is giving me a terrible fit. I have 4 columns that are full of product but yet it is showing "sold out" It doesn't have a sold out tab so as it uses a drop sensor to provide info on if there is product in the machine or not. I have test vending all columns and the products drop just fine. Any help would be awesome! Link to comment Share on other sites More sharing options...
Snoopy Posted June 30, 2017 Share Posted June 30, 2017 I had that problem once, after unplugging it and counting to 10 and plugging it back in, it seemed to clear the sold out msgs. Hope this helps. Link to comment Share on other sites More sharing options...
WheelofDeath Posted June 30, 2017 Share Posted June 30, 2017 Check your door switch, be sure the machine resets. You could have a bad switch, loose wires. Link to comment Share on other sites More sharing options...
Southeast Treats Posted July 1, 2017 Share Posted July 1, 2017 good suggestions, opening the door is supposed to reset the sold out selections.... and you need to check the columns for jams and the motors for proper function, if product is not dropping when the column is loaded that would cause the sold out to begin with. You can also go into the service mode and reset your error codes. Link to comment Share on other sites More sharing options...
AZVendor Posted July 1, 2017 Share Posted July 1, 2017 As stated, the door switch is supposed to reset your sold out conditions. If you have had the columns jam or sell out in the past which preceded this condition then your door switch is at fault. If, instead, this problem is in the corner columns then you need to increase the sensitivity of your drop sensor by 1/4 turn. After any drop sensor adjustment you must then test all columns to ensure the adjustment didn't mess up any other columns. Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.