Jump to content
[[Template core/front/profile/profileHeader is throwing an error. This theme may be out of date. Run the support tool in the AdminCP to restore the default theme.]]

Sir SnackAlot Vending last won the day on December 15 2018

Sir SnackAlot Vending had the most liked content!

Community Reputation


About Sir SnackAlot Vending

  • Rank
    Add your text here

Profile Information

  • State
  • Vending Type
    Full Line
  • Vending Since

Recent Profile Visitors

501 profile views
  1. Crazy question but do you happen to have the guaranteed vend sensors as well to go with the kit? If Yes, how much for the entire kit?
  2. D&S vending has a 10% off special going on the InOne boards until the end of the year. Contact your sales representative to get the special pricing.
  3. Make sure that you compare the Vendors Exchange board (kit) as well. The kit is cheaper and from what I hear there are less problems with the guaranteed vend system because there is just one board and reflective tape installed on the other side, which translates to less parts to go faulty. The InOne kit does offer the ability to use dumb mechs instead of the mandatory upgrade to MDB, if I remember correctly.
  4. Yep, you have it all figured out what is required to replace these selections. Personally I sell Gum (small 5 stick pack), Starburst and Mentos from these slots and they actually do well. If you decide to go this route make sure to test vend them several times to make sure that your iVend is not allowing you to give away free product.
  5. Some years ago, I purchased a 501e that was on casters. I was very surprised to see this and found that it made the machine very easy to move but it is hard to imagine such a machine on location on casters. The casters were heavy duty and look like something that I have seen in Northern Tools, take a look in there and I think you will find what you are looking for. If you decide to take the tour in Northern Tools you will also find some three wheeled dollies that will work well for the snack machine, just make sure to get the proper rating so that the weight of the machine will be properly supported.
  6. Hey guys, I know the price will vary by the region but what is your normal sales price for these?
  7. I know this crazy to reply two years later guys but for thread closure replacing the gate links did resolve the issue on this one. Thanks again for the help! I had already thanked Randy after the fix was performed but in a much timelier manner. 😁
  8. The Stevens at $175 is a heck of a deal that you should not miss. If you don't mind the hard work sounds like there is an opportunity to go into the machine moving business in your area. 😁
  9. The bank takes all of my mutilated coins and bills without any issue.
  10. I ran the calibration procedure and it did not resolve the issue so I continued to investigate and troubleshoot the issue. I have several of these AMS machines but noticed on this one that there are sensors in the bottom portion of the delivery tray so I popped them out, with the power Off, and there was a huge dust bunny on the detector sensor. I removed the dust bunny, checked & cleaned the emitter, ran the calibration again and Voila issue resolved! I would like to thank you guys for lending a helping hand as you are always willing to do.
  11. Thanks AZ! I actually did a portion of this but had no idea how to evaluate the parameters that was received. Thanks again, I will try it out this week.
  12. Thanks lacanteen. I was looking at the sensors when I observed the error and attempted to clean them but the error did not go away. I also made sure that the door wasnot blocking the sensors. How do I verify if I have a faulty emitter or receiver?
  13. Hey guys I need a little help with an AMS 639 machine that accepts money, coins and bills, then displays remove product on the display and will not allow any products to be dispensed but it will return your money if the coin return button is pressed. Thanks in advance for your help!
  • Create New...