Search the Community
Showing results for tags 'coast to coast'.
Found 2 results
Have two Coast to Coast Challenger cranes. On both claws, the voltage will not increase over 35v, even though there's plenty of room left to turn the knob. In test mode, the VR3 shows 45v, but on this crane, it's a default max setting and I cannot alter the VR3. I measure these at the terminal above the claw during test mode. The analog meters in both games work and match my meter readings. The coil and pots have been changed on one, but not the other (since there was no improvement). The power supply also reads 49.6v at the power supply, and drops to 44.1v when activating the VR1 in test mode. I'm at a loss on this. Especially since both claws are doing this. Please advise?
I have a Betson Big Choice game that I recently had to order a new coast to coast mother board for...I still have one problem that is still present. Every 3 or so plays the meter will think it has won a prize when it did not. I have already replaced the sensor and checked the wires for any splices & such... I have also tried unplugging the lights as some of these games have problems with the glare (or short in wiring) which I have still not fully understood why sometimes that works. But in this case unplugging the lights still didn't work either. I need accurate numbers to keep track of the payout on this crane at my entertainment center. Any suggestions would be gresatly appreciated!