Jump to content

Vendo 480D


CajunCandy

Recommended Posts

The bill acceptor in my Vendo take dollar and holds it, will not stack dollar until I press a selection then it will stack it and pay out change. I have two columns set up for 20 oz. powerade and gatorade at $1.25 each and I would like to have bill acceptor to take two one dollar bills and give .75 change back. Can some body tell me how to program it for that.

The machine is mutiprice and I can set all ten columns at different prices. Bill acceptor is a BA30B and the coin acceptor is a 9302gx mdb.

Thanks

Link to comment
Share on other sites

You need to find and adjust the escrow setting in the machines board.

Do you have a manual?

I am afraid that if you get it to take 2 bills that should you press the coin return your machine will become a changer and you will run out of change in your mech and lose sales.

Walta

Link to comment
Share on other sites

Thanks Walta

I only have what I down loaded from the net, will look and see if it show how to adjust it.

When I press the coin return now it will not give me back my dollar, it just sits in acceptor just out of view.

Link to comment
Share on other sites

That sounds more like a coin mech problem.

Walta

Thanks again!

Replace coin mech, now it spits dollar back and returns the change I put in.

My $100 dollar cold drink machine now have cost me a cooling deck, had the ba30b rebuilt,replaced the coin mech!

now just to test it for a couple more days, it's off to it's location.

Link to comment
Share on other sites

Archived

This topic is now archived and is closed to further replies.

×
×
  • Create New...