arkhusker Posted March 7, 2014 Share Posted March 7, 2014 So, I have tried two different BA30SA's in this machine and check the various settings in the programming. I'm stuck and this is a really good account. Any ideas? Link to comment Share on other sites More sharing options...
AZVendor Posted March 7, 2014 Share Posted March 7, 2014 Check your setting on switch 3 in the validator control box. Switch 3 controls the pulse width that the validator puts out. Since this is a later 157 the machine harness should be plugged into the white 9 pin connector for power and the 18 pin black connector should be plugged into the bottom of the validator control board. If by chance you ONLY have the white 9 pin connector then you will need a dummy plug for the 18 pin socket, but I seriously doubt that the 157 would be using that simple harness. Link to comment Share on other sites More sharing options...
arkhusker Posted March 7, 2014 Author Share Posted March 7, 2014 SOLVED! Call it a blonde moment at the end of a long day! Link to comment Share on other sites More sharing options...
CajunCandy Posted March 7, 2014 Share Posted March 7, 2014 SOLVED! Call it a blonde moment at the end of a long day! I thought only I had long days? How simple was it? Link to comment Share on other sites More sharing options...
arkhusker Posted March 7, 2014 Author Share Posted March 7, 2014 putting in a 110V val instead of a 24V! my initial attempts at replacement weren't 30SA's but 32SA's Link to comment Share on other sites More sharing options...
CajunCandy Posted March 7, 2014 Share Posted March 7, 2014 Hmmmmmmmmmm! Yep! That was a blonde moment. Have a Great Weekend! mike I ate shrimp & crab stew with the egg and potato salad and corn. Gooood! Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.