SeaTurtle Vending Posted July 6, 2014 Share Posted July 6, 2014 My Coinco 9300 in an AP LCM4 machine is not dispensing quarters. It clicks, but the quarters do not dispense. These coin changers are quite common and I have a few backups, so I am just going to switch it out. However, I am hoping to salvage this one as well. Anyone have any thoughts on fixing it? Link to comment Share on other sites More sharing options...
AZVendor Posted July 6, 2014 Share Posted July 6, 2014 The coin payout issue can only be corrected by rebuilding the coin mech and replacing the coin payout parts that wear against each other. You can send me a PM if you'd like me to send a replacement. Link to comment Share on other sites More sharing options...
SeaTurtle Vending Posted July 6, 2014 Author Share Posted July 6, 2014 Thanks AZ. I have a few in reserve so I will hold off for now. Link to comment Share on other sites More sharing options...
Feral Vending Mechanic Posted July 7, 2014 Share Posted July 7, 2014 It's also possible that you have a gum encrusted ( or maybe bent ) coin on the bottom of the quarter tube. Dump that tube and examine the bottom two quarters. Link to comment Share on other sites More sharing options...
AngryChris Posted July 7, 2014 Share Posted July 7, 2014 A damaged coin can cause this problem. You have to empty the quarter tube and put the quarters closest to the dispenser in a bag (so they don't go back in the machine) and put about 10 quarters back in and test. If it keeps clicking, it needs repaired. Link to comment Share on other sites More sharing options...
SeaTurtle Vending Posted July 7, 2014 Author Share Posted July 7, 2014 Repair 101. Why in the hell did I not think about a possible bent quarter. DOH! Link to comment Share on other sites More sharing options...
Feral Vending Mechanic Posted July 9, 2014 Share Posted July 9, 2014 If the slide on the bottom of the coin mech is nasty with filth, you can clean it up with a bit of rubbing alcohol. Link to comment Share on other sites More sharing options...
AngryChris Posted July 10, 2014 Share Posted July 10, 2014 Repair 101. Why in the hell did I not think about a possible bent quarter. DOH! Did you get it fixed? Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.