CaptainMike Posted August 4, 2014 Share Posted August 4, 2014 I have a DN 5591 glass front. I am trying to use some VMS but the machine is not reporting DEX data via my eport. I checked all the cabling and it all looks good with the telemeter plugging into a male to female adapater, which has a little 3 pin plug that plugs into the board. The error is MACHINE CONNECTION/CABLING ISSUE. I unplugged these connections and then plugged everything in again...then hit fill/dex and still same issue. Could my eprom need to be updated? Currently the chip on my board, which I think is the version, says "030.61, GFV CTRL". I assume no one has updated it since the machine was made years ago most likely... Link to comment Share on other sites More sharing options...
AZVendor Posted August 4, 2014 Share Posted August 4, 2014 There might be two similar DEX ports and if there's another another to use try that. As far as the software version, I believe that there is still a later version available for the 5591. This same issue comes up in some Vendo boards due to outdated DEX software. I can look into this for you and get you the later eprom. Link to comment Share on other sites More sharing options...
Feral Vending Mechanic Posted August 4, 2014 Share Posted August 4, 2014 What software are you using? If it's MEI's software, I can tell you that it's really picky about DEX ID numbers. Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.