kdub3821 Posted May 9, 2015 Share Posted May 9, 2015 Got a error code and can't find any info on what the m2 error is using the manual and the search on this forum. Thanks Link to comment Share on other sites More sharing options...
AZVendor Posted May 9, 2015 Share Posted May 9, 2015 M02 is water tank not full or M20 is waste bucket is full. If the code is M02 then as I mentioned before, the water tank takes two fill cycles to fill the tank. If you ran two cycles and the heater didn't come on then you have low water pressure, a clogged water filter, too small a water line or a bad inlet water valve. If the code is M20 then check your float switch on the waste bucket. If it seems okay but doesn't enable the machine then you have a bad switch. Link to comment Share on other sites More sharing options...
kdub3821 Posted May 9, 2015 Author Share Posted May 9, 2015 I made sure once the water stopped the first time to lift the float and start the second cycle. I also hear the heater kick on. My first guess will be the water pressure. The water hook up is off of a shut off valve from the sink next to the machine. I only cracked the valve open in fear of a leak. I'll try that first to see. If it is a filter or inlet valve do you have them in stock AZ? Also I'm sure the filter would not be hard to change but is the valve something difficult to replace? Thanks Link to comment Share on other sites More sharing options...
kdub3821 Posted May 9, 2015 Author Share Posted May 9, 2015 Also it sounds like a fan is always running. Is that normal? Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.