OEMVENDING Posted September 7, 2015 Share Posted September 7, 2015 I have a 7600 series and the fluorescent bulb and screen have stopped working and ideas what this could be ? Link to comment Share on other sites More sharing options...
cvending Posted September 7, 2015 Share Posted September 7, 2015 First of all, are you sure you have power to machine? Sounds obvious but sometimes overlooked. If you do have power, will machine accept coins? If so, wil it vend? There are a couple circuit breakers near the on/off switch. Check them too. Link to comment Share on other sites More sharing options...
AZVendor Posted September 7, 2015 Share Posted September 7, 2015 This sounds like you have no power to the machine at all. The lights will always have power direct from the line cord. The logic board and coin mech power come through a power board next to the logic board but also fused (on a circuit breaker) at the power supply which is located on the left side of the cabinet below the bottom shelf. Inspect your power cord from the wall to the machine for any damage. It's very possible that the machine was bounced and that a leg has pinched and broken a wire in the power cord. Of course, you must first check that you have power to the outlet in the wall. Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.