acvacho Posted September 16, 2015 Share Posted September 16, 2015 I purchased a used Savamco LC62 and it didn't come with a manual. I can't figure out how to change the set prices. I've searched for hours online for a manual, but it comes up blank. The company is now out of business. HELP! Link to comment Share on other sites More sharing options...
CajunCandy Posted September 16, 2015 Share Posted September 16, 2015 http://vendiscuss.net/index.php?/files/file/95-savamco-programming/ This link will bring you to it! cajun Link to comment Share on other sites More sharing options...
acvacho Posted September 16, 2015 Author Share Posted September 16, 2015 That's a single page... Link to comment Share on other sites More sharing options...
CajunCandy Posted September 16, 2015 Share Posted September 16, 2015 try again. I fixed it! Link to comment Share on other sites More sharing options...
acvacho Posted September 16, 2015 Author Share Posted September 16, 2015 This manual isn't for the SavmanCo LC62. I was able to download this one earlier, but it isn't correct. Link to comment Share on other sites More sharing options...
AZVendor Posted September 16, 2015 Share Posted September 16, 2015 If it's not correct then you are probably SOL as there is very little on the internet for these machines. Do a search for the LC62 manual and you might find one that can be downloaded for a fee. It's too bad you didn't research the machine, especially on this forum, so you could have avoided putting money into an old relic. Link to comment Share on other sites More sharing options...
Walta Posted September 16, 2015 Share Posted September 16, 2015 As I recall there was a label on the logic boards cover with price setting instruction. You may find the cover in the bottom of the machine. Walta Link to comment Share on other sites More sharing options...
Bandmate Box Posted October 9, 2015 Share Posted October 9, 2015 There should be a red square button on the mother board. Push that button and the number of selections should appear. 24 is what mine has. After it flashes the number push 4 and it should say price. Then you can select each slot and use the arrows to adjust prices. If you press 5 after pressing the red button you will be able to test the motors individually. Press 6 to test them all. Once done make sure you press the red button again to save your settings. Hope that helps. Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.