laip51 Posted September 22, 2015 Share Posted September 22, 2015 Everything working fine on refurbed 113 except sequence of shelves. A thru D vend ok. Selecting items on E doesn't vend. Selecting items on F vends E items and so on down. Seems to skip E in the sequence. Have run out of ideas. Anybody with same situation? Link to comment Share on other sites More sharing options...
cvending Posted September 23, 2015 Share Posted September 23, 2015 Had the machine been working properly prior to the refurb? I think it sounds like the harness for,the shelves got interchanged. Link to comment Share on other sites More sharing options...
AZVendor Posted September 23, 2015 Share Posted September 23, 2015 It's kind of hard to mix up the shelf harnesses on APs. There's only one connector from the board so wires would have to be physically moved in the connector to change anything there. The cabinet back harness connectors are spaced to only allow placement in the correct locations behind the shelves. If F and G were both moved up one position to exclude the E connector then that wouldn't work because the G (gum/mint) connector won't fit a normal snack shelf. So this likely means that the cabinet back harness is bad or the logic board is bad. Link to comment Share on other sites More sharing options...
rmorris1953 Posted September 23, 2015 Share Posted September 23, 2015 I would have to agree with AZ someone has tampered with harness. Check harness with wiring diagram to see if the pins on shelf E are in the correct position. May have a broken wire that someone has spliced incorrectly or pulled a pin out when replacing board and put it the wrong position. Link to comment Share on other sites More sharing options...
lacanteen Posted September 23, 2015 Share Posted September 23, 2015 Could be bad keypad. When you push "E" what comes up on the display? Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.