Jump to content

Dixie narco e model can problems


philJ

Recommended Posts

Just picked up a vending machine and trying to load soda cans into it. We don't know if we have the right cam stop shim. The machine will load three into the cylinder and not dispense. Then it will dispense one, next it dispenses two, finally back to none repeating this.

Link to comment
Share on other sites

You did not say which column this was, or if just one selection is doing this or all of them. If it's the right wide column, the gray/red cam should be set on 2. In the single columns, the brown cam should be set on 1 and there should be a gold rod in the rotor. If just one column is doing this, empty and look at a column is working and see what might be different.

Link to comment
Share on other sites

In addition, your narrow column requires a can shim on the right side of the column which is 1/2" thick.  If you have a 1/4" thick shim then that is for bottles and will cause issues with cans.  In a wide column you'll need 4 - 3/32" shims on each side of the column.  Those should not be 1/2 height shims but rather full height shims for cans.

Link to comment
Share on other sites

Archived

This topic is now archived and is closed to further replies.

×
×
  • Create New...