beameupscotty Posted October 6, 2015 Share Posted October 6, 2015 HI everybody, I just bought a new ICT bill accepter - dose anybody have a 1 800 vending machine or has replaced there bill accepter becase i ran out of ideas here when i am in test mode it go green but when i put it in ready for sale it turns yellow not shore what to do here at this point. is there something i am missing or over looking its a the ICT is a BL-700-usd4 thank you scott Link to comment Share on other sites More sharing options...
CajunCandy Posted October 6, 2015 Share Posted October 6, 2015 Did you check your dip switches on old bv to the new one you put in? Maybe it set differently. cajun Link to comment Share on other sites More sharing options...
Walta Posted October 6, 2015 Share Posted October 6, 2015 If the coin mech full of coins? If it is low the board will turn off the bill acceptor. Walta Link to comment Share on other sites More sharing options...
0dhyn0 Posted October 7, 2015 Share Posted October 7, 2015 i'm not familiar with ICT bill acceptor. i used NRI and its still working for almost 3 years without major problem. Link to comment Share on other sites More sharing options...
AZVendor Posted October 7, 2015 Share Posted October 7, 2015 i'm not familiar with ICT bill acceptor. i used NRI and its still working for almost 3 years without major problem. You must be in Europe if you are using NRI products. We don't have that line in the US> Link to comment Share on other sites More sharing options...
lacanteen Posted October 8, 2015 Share Posted October 8, 2015 ICT units are primarily used in gaming applications that have no inhibit line. As someone else said, check DIP switch settings. If it was new there should be a matrix explaining each DIP function. Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.