BlindVending Posted December 6, 2015 Share Posted December 6, 2015 I have a 167 that one selection just won't vend and says make a new selection over and over. I changed trays and still same thing and that tray works fine elsewhere. I ordered and finally received an entire new main harness that I believe hooks to the board and each tray. I've never installed one before. Is this easy? Do I need to remove every tray out of machine to do this. After I change it do I need to reconfigure anything in the settings of the machine. Currently my non working selection doesn't even show up in the settings Link to comment Share on other sites More sharing options...
Feral Vending Mechanic Posted December 9, 2015 Share Posted December 9, 2015 The 167 has smaller shelf boards mounted on the right side of the rails. I've had these go bad and cause that exact problem. I've been working on 167s for nearly 15 years now, and I've never seen a bad main harness. ( Not to say that it couldn't happen, just that I've never seen that as the problem. ) Link to comment Share on other sites More sharing options...
BlindVending Posted December 9, 2015 Author Share Posted December 9, 2015 Alright thanks for the help guys. I feel like my tech isn't the greatest. I have the harness now so might as well try it. If not I will revert to the other suggestions here. Thanks again! Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.