allprovending Posted December 9, 2015 Share Posted December 9, 2015 On my crane the Power on(LED 1) light is a steady red but the Flashing Heartbeat(LED 2) isn't on at all. What do I look for to try and get this fixed? Link to comment Share on other sites More sharing options...
AZVendor Posted December 10, 2015 Share Posted December 10, 2015 The left LED 1 is for power and when lit solid it indicates the logic board has proper voltage in. The right LED 2 is the logic heartbeat and if it's not flashing you either have a bad coin mech, validator or logic board. Try unplugging the mech and validator then power up and check for the heartbeat. If still not on you need a new board. If it is on then power off and try just the coin mech. If it stops the heartbeat then the mech is bad. If flashing then do the same with the validator. If none of this helps then before you change the board, locate the coin mech power board and see if it has a blown fuse on it (possibly caused by a bad mech or validator). That board could also show burn marks if bad. Link to comment Share on other sites More sharing options...
allprovending Posted December 10, 2015 Author Share Posted December 10, 2015 Ok thanks.....I will check all that tomorrow. Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.