smartvendnw Posted June 1, 2016 Share Posted June 1, 2016 Setting up my iVend purchased directly and the coin acceptor wasn't connected. Now never doing this before I believe I connected it correctly as the lights came on. Now do I need to do anything else? A red and yellow light are lit. Nothing in the machine manual. Thanks!! Sent from my iPhone using Tapatalk Link to comment Share on other sites More sharing options...
AZVendor Posted June 2, 2016 Share Posted June 2, 2016 Those lights are normal I think and if they flash then there's an issue. If the mech accepts coins and works fine then the lights are normal. Link to comment Share on other sites More sharing options...
smartvendnw Posted June 2, 2016 Author Share Posted June 2, 2016 Yup everything checked out great! Phew. Sent from my iPhone using Tapatalk Link to comment Share on other sites More sharing options...
BlindVending Posted June 2, 2016 Share Posted June 2, 2016 For now. Those mechs are terrible Link to comment Share on other sites More sharing options...
smartvendnw Posted June 2, 2016 Author Share Posted June 2, 2016 For now. Those mechs are terrible What's the common issues? Sent from my iPhone using Tapatalk Link to comment Share on other sites More sharing options...
lacanteen Posted June 2, 2016 Share Posted June 2, 2016 What's the common issues? Sent from my iPhone using Tapatalk Dust/dirt failures on upper tube sensors. General coin jams. If it's in a clean environment it'll be fine. That Coinco BP bill acceptor will fail in less than 2 years (drive motor). Link to comment Share on other sites More sharing options...
smartvendnw Posted June 2, 2016 Author Share Posted June 2, 2016 Ok noted. I'll be prepared to replace once I get through phase one here. Thanks. Sent from my iPhone using Tapatalk Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.