CajunCandy Posted June 15, 2016 Share Posted June 15, 2016 Polyvend R32 Ultravend giving a E1 code on display. Azvendor or someone knows what it means? No trouble shooting or codes in manual. Thanks cajun Link to comment Share on other sites More sharing options...
AZVendor Posted June 16, 2016 Share Posted June 16, 2016 It might mean that selection E1 is not available, if you have an E shelf. In that case look for a broken wire above the connector on the right side rail. As those wires bend forward and back when the shelves are pulled out the oftentimes will break. Otherwise it might be that selection E1 has a problem like too little current. If the motor has jammed it could set an error code. Link to comment Share on other sites More sharing options...
CajunCandy Posted June 16, 2016 Author Share Posted June 16, 2016 There is no column E. No motor jams. It's just strange for the code it is giving. cajun Link to comment Share on other sites More sharing options...
lacanteen Posted June 16, 2016 Share Posted June 16, 2016 I'm going to sit this one out. (It's bad power) Link to comment Share on other sites More sharing options...
Snickers Posted May 3, 2018 Share Posted May 3, 2018 I got a call from someone with this same problem today. I looked to find an answer for them and could not find any info other than this old post. Link to comment Share on other sites More sharing options...
lacanteen Posted May 4, 2018 Share Posted May 4, 2018 It's a power issue, either from the wall or more likely a failing transformer. Link to comment Share on other sites More sharing options...
Snickers Posted May 4, 2018 Share Posted May 4, 2018 Thanks George. I will call them back and let them know. TGIF Link to comment Share on other sites More sharing options...
CajunCandy Posted May 4, 2018 Author Share Posted May 4, 2018 As I was explained by the people who fixed that board, a diode on board is going bad. Never did have that problem after the board was repaired. Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.