newguy47591 Posted August 25, 2016 Share Posted August 25, 2016 Bought 2 of these AP snackshop 4 wides today ..one has a dba, one dont... one needs a changer as its bad (i tested changer from other one on it and it works great...so ill replace changer..)..one is missing three motors also but that shouldnt be a big issue..my one big concern is this i put money in it and the keypad isnt working.. sometimes if you press super hard you can get a few of the letters to show up but no numbers..so i assume keypad needs replaced..how hard is this to do and where do I get parts? Thanks! Link to comment Share on other sites More sharing options...
AZVendor Posted August 25, 2016 Share Posted August 25, 2016 Email me at rbepic4gatgmaildotcom and I can send you any parts that you need. I can send you instructions for replacing the keypad as well. Link to comment Share on other sites More sharing options...
AngryChris Posted August 25, 2016 Share Posted August 25, 2016 I have not replaced the keypad but I have probably done 80% of the steps needed to replace one. I don't think it's difficult and there are several sources for such parts. AZVendor may have one but you can also try D&S Vending or Vendor's Exchange in addition to many other distributors.You should check your connections. If I am not mistaken, there are two ribbon cables that connect to the keypad. They are located just above the keypad and sort of behind the display. When you slide the door out, you'll have to look closely to see those two ribbon cables. They are pretty much identical and there is almost NO slack in them. Make sure they are properly connected but be careful as the pins are VERY fine and can be bent VERY easily. Just visually inspect to make sure they are both connected.Aside from that, if you still need a keypad, then I guess you can wait for AZVendor or call the said distributors.It is also possible (I think) that something is stuck between the keypad and the plastic buttons. Perhaps all you need is to remove the keypad and make sure nothing is stuck in there. I'm not sure if the AP is like USI machines, but sometimes you need to tape the plastic buttons BEFORE you take the keypad out so the buttons don't all fall out. By the way, since those appear to be AP 6600's, and you need so many parts, I recommend upgrading the board to something such as a VE UCB or InOne board and make everything MDB inside. Link to comment Share on other sites More sharing options...
newguy47591 Posted August 25, 2016 Author Share Posted August 25, 2016 Email me at rbepic4gatgmaildotcom and I can send you any parts that you need. I can send you instructions for replacing the keypad as well. do you think replacing the keypad will fix this issue? Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.