crunchydog Posted March 19, 2017 Posted March 19, 2017 I bought a used dn pop machine with a flush mount screw type t handle, everything works but the handle is not operating right, I believe it's missing a piece or two, does anyone have a complete diagram of assembly on these??
Technivend Posted March 19, 2017 Posted March 19, 2017 If the t part screws in as you tighten the machine, it is the e clip inside the handle assembly. If you remove the e clip from the back of the handle assembly and slide the t part out, you should see the e clip floating around. Slide the spring and everything towards the front of the t and reattach the clip. Then reassemble the whole t handle assembly.
lacanteen Posted March 19, 2017 Posted March 19, 2017 Several DN manuals here: http://vendiscuss.net/index.php?/files/category/8-ebooks-manuals-amp-periodicals/
crunchydog Posted March 19, 2017 Author Posted March 19, 2017 Did not find any diagrams on the handle to dl, the person I bought it off of messed with the handle and lost parts it does not screw in right.
Technivend Posted March 19, 2017 Posted March 19, 2017 I checked a few manuals and tried to find an exploded view with no luck. Even looked on YouTube to see if there a video. If parts are missing you'll be hard pressed to just get those parts. May be time just to order a new t-handle.
57thTom Posted March 19, 2017 Posted March 19, 2017 Really? I think I was looking at one in a Vendo manual just the other day. Locks aren't built by the vending machine manufacturer so they should be interchangeable.
lacanteen Posted March 19, 2017 Posted March 19, 2017 Page 14 of the E-Model parts manual is very explicit.
Technivend Posted March 19, 2017 Posted March 19, 2017 For the most part they are. The fact that they don't make them means they don't sell parts for them, just the whole assembly.
Recommended Posts
Archived
This topic is now archived and is closed to further replies.