JJVend Posted May 12, 2017 Share Posted May 12, 2017 I just replaced two motors and it still says make another selection... I had a previous post about it and was advised to toggle the interlock switch so the machine can recognize new motors. Also got advised to power off and on again. Neither recommendations worked.. I'm stuck, can these machines be reset to factory settings? Would that solve my motor problem? Any chance that it is not a dead motor that is making the make another selection error? Link to comment Share on other sites More sharing options...
JJVend Posted May 12, 2017 Author Share Posted May 12, 2017 Sorry duplicate thread Link to comment Share on other sites More sharing options...
cvending Posted May 12, 2017 Share Posted May 12, 2017 Is this 147 factory or has it been updated? Link to comment Share on other sites More sharing options...
arkhusker Posted May 12, 2017 Share Posted May 12, 2017 Your shelf contacts might not be making connection at the back of the machine. If it has been updated with a shelf kit (wiring harness to each shelf and small pcb board on the rails) then you may have a wire broken on the shelf that is giving you trouble. Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.