Jump to content

Validator replacement in rotary merchandiser


Recommended Posts

If you aren't using anything other than the 9 pin connector and your machine can't disable the bill acceptance (as in a correct change situation) then you can use an MEI gaming validator like the VN2300 mounted as a downstacker, I believe.  This is an "always enabled" validator.  The GL5 is 110v by the way so you need the 2300.

Link to comment
Share on other sites

2 hours ago, AZVendor said:

The GL5 is 110v by the way

I don't know anything about this bill acceptor, but the manual says there are both a 115V and a 24V version.  24 V uses pins 5&6 for power, 115 V uses pins 4&6.

Link to comment
Share on other sites

  • 3 weeks later...

Archived

This topic is now archived and is closed to further replies.

×
×
  • Create New...