fhamann Posted July 14, 2017 Share Posted July 14, 2017 I have a Snack Shop II Model 2099 with the following problem. If I insert a bill, the machine works normally. If I insert coins, the coins are accepted, but the display won't show the credit for about 10 seconds for each coin. If you insert the coins after each is accepted (10 seconds), everything is fine. If you insert the coins before the display shows the credit, the coin just falls through to the coin return. What could be causing this? The coin mech is Coinco, 24 volt, and the bill acceptor is a Coinco BA. regards, Frank Orange, CA Link to comment Share on other sites More sharing options...
rmorris1953 Posted July 14, 2017 Share Posted July 14, 2017 If you haven't tried a different coin mech yet I would. Link to comment Share on other sites More sharing options...
AZVendor Posted July 14, 2017 Share Posted July 14, 2017 Yup. Change the coin mech but it will need to be a 12 pin 24v mech, not a 15 pin. Email me at rbepic4gatgmaildotcom if you need one. Link to comment Share on other sites More sharing options...
fhamann Posted August 8, 2017 Author Share Posted August 8, 2017 I tried 2 other coin mechs with no effect on the problem. There is still a 10 second delay between dropping in the coin, and the credit showing up on the display. Does anyone know where I can buy a control board for this AP model 2099 snack machine? Here are photos. Link to comment Share on other sites More sharing options...
AZVendor Posted August 8, 2017 Share Posted August 8, 2017 That is not an AP machine but at USI Snackmart II. Email me at rbepic4gatgmaildotcom and I'll see if I have one for you. Link to comment Share on other sites More sharing options...
fhamann Posted August 18, 2017 Author Share Posted August 18, 2017 Hi AZ. I sent you an email a week or so ago and have not seen a reply. Do you have the control board I need? thanks, Frank Link to comment Share on other sites More sharing options...
AngryChris Posted August 18, 2017 Share Posted August 18, 2017 If it were me, I would scrap that machine. Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.