Coal River Vending Posted January 17, 2018 Share Posted January 17, 2018 Any suggestions? Link to comment Share on other sites More sharing options...
AngryChris Posted January 17, 2018 Share Posted January 17, 2018 Unplug the power and plug it back in. See if it even cycles on. If no luck, check all harness plugs and make sure it's definitely plugged into the validator on thr side. If still no luck, have the validator repaired. Link to comment Share on other sites More sharing options...
Coal River Vending Posted January 17, 2018 Author Share Posted January 17, 2018 Tried other harnesses and validators. Nothing. Link to comment Share on other sites More sharing options...
orsd Posted January 17, 2018 Share Posted January 17, 2018 Check the fuses. They are under the steel cover on the main board. Link to comment Share on other sites More sharing options...
AZVendor Posted January 17, 2018 Share Posted January 17, 2018 If the coin mech has power then it's a bad validator though the MDB runs through the validator to the coin merch. Link to comment Share on other sites More sharing options...
Coal River Vending Posted January 17, 2018 Author Share Posted January 17, 2018 2 minutes ago, AZVendor said: If the coin mech has power then it's a bad validator though the MDB runs through the validator to the coin merch. Checked fuses. There are 2 harnesses coming off the board. One to mech which is marked MBD and one to validator. It’s a mars tech-6510 mbd Link to comment Share on other sites More sharing options...
orsd Posted January 18, 2018 Share Posted January 18, 2018 If you are running an MDB mech (which you are) then validator should be on the same chain/ harness as the coin mech, and should go to the same place on the board. The fact that you have one harness from board to mech and one from board to Val tells me that you are running a 110v validator on a different pulse protocol. You can’t do that, has to be an MDB Val, which the mech is daisy changed to. Link to comment Share on other sites More sharing options...
NYCandyMaN Posted January 19, 2018 Share Posted January 19, 2018 most likely if the acceptor is running pulse, it will not work, there are some that run both pulse and 12v, and some are 12v and 24v, check what you have, but either way it should power on Link to comment Share on other sites More sharing options...
AZVendor Posted January 19, 2018 Share Posted January 19, 2018 Only the Coinco BA/Mag 110v validators will run both pulse and MDB. Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.