orsd Posted January 30, 2018 Share Posted January 30, 2018 So just picked up an AP LCM 2, but when I try to vend it the motor just turns a couple degrees and stops. Any ideas? Link to comment Share on other sites More sharing options...
57thTom Posted January 30, 2018 Share Posted January 30, 2018 No no no no please don't ask me no more..... Link to comment Share on other sites More sharing options...
AZVendor Posted January 30, 2018 Share Posted January 30, 2018 All motors or just one? If one then a bad motor, if all then a bad board. You might want to check the output voltages from the transformer first. You could also unplug the mech and validator to see if that fixes it. Those are the obvious things. Link to comment Share on other sites More sharing options...
orsd Posted January 31, 2018 Author Share Posted January 31, 2018 I’m getting 26v Also there is only one thing plugged into the transformer, is that right? Link to comment Share on other sites More sharing options...
lacanteen Posted January 31, 2018 Share Posted January 31, 2018 26v is good. As AZ asked, is it one motor or all? If there is a gum tray slide it out & test a motor on another shelf. If there is a grounded wire that's usually where it is. If still no luck, slide out all shelves except for the A tray & test a motor on that tray. If you need a board I have boxes of them. Link to comment Share on other sites More sharing options...
orsd Posted February 1, 2018 Author Share Posted February 1, 2018 It’s all of them. Did what you said, nothing. Link to comment Share on other sites More sharing options...
lacanteen Posted February 1, 2018 Share Posted February 1, 2018 Time to try a board. Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.