Thunder Bay Vending Posted November 19, 2019 Share Posted November 19, 2019 Ok I have a vending machine where A2 is working but NOT B2,C2,D2,E2, What gives? Loose wires? ground? Any insight before I start tearing it apart, I tried forcing a motor check but just says fail when I do B2thruE2.. Link to comment Share on other sites More sharing options...
AZVendor Posted November 19, 2019 Share Posted November 19, 2019 (edited) The #2 circuit is broken somewhere between the A and B shelf. Either a bad shelf connector on A or B or a loose, broken or pinched #2 wire. Edited November 19, 2019 by AZVendor Link to comment Share on other sites More sharing options...
Thunder Bay Vending Posted November 21, 2019 Author Share Posted November 21, 2019 Ok checked all wiring on each shelf no disconnected wires, could bad motor cause this? Link to comment Share on other sites More sharing options...
AZVendor Posted November 21, 2019 Share Posted November 21, 2019 It might but it will take some trial and error. Change each affected motor one at a time. You only need one new motor to accomplish that. Link to comment Share on other sites More sharing options...
Corvus Corax Posted November 27, 2019 Share Posted November 27, 2019 Have you tried moving the whole tray to another position. Link to comment Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now