AngryChris Posted December 22, 2019 Share Posted December 22, 2019 I Just acquired a location with 2 machines. There is an AP 112 with what looks like an InOne kit on it. When the door switch is pressed, it says sensor disabled due to blockage or something along those lines. There is nothing there. Is this likely just a bad drop sensor? Link to comment Share on other sites More sharing options...
Chard Posted December 22, 2019 Share Posted December 22, 2019 Did you clear the errors from the menu? 1 Link to comment Share on other sites More sharing options...
NYCandyMaN Posted December 30, 2019 Share Posted December 30, 2019 I would check the connections Link to comment Share on other sites More sharing options...
LVS Posted January 1, 2020 Share Posted January 1, 2020 I have one that does that. Try just closing door, wait a few seconds and message should disappear and go to your selection message. Link to comment Share on other sites More sharing options...
AngryChris Posted January 1, 2020 Author Share Posted January 1, 2020 32 minutes ago, LVS said: I have one that does that. Try just closing door, wait a few seconds and message should disappear and go to your selection message. It does, but the sensor is disabled. I'm leaving it alone for now and I'll try a drop sensor once I install a kit in another AP 112/113 so I can conclude if the sensor is the problem or not. Link to comment Share on other sites More sharing options...
Chard Posted January 1, 2020 Share Posted January 1, 2020 If you don't clear the errors on a Inone kit, the error will remain. Call InOne tech support and they can walk you through it. Link to comment Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now