Jump to content

Recommended Posts

I just switched out two spirals on my AP123 to 6 count spirals. They were previously 10 count spirals. My issue is the new spirals (6 count) are vending 3 rotations/items when they are selected. Is there something I missed? Do I need to change the spiral count in the setup menu somewhere? If so, where is it? I couldn't seem to find it.

Share this post


Link to post
Share on other sites

Does it have a drop sensor?  Is it only that selection?  Did you change the motor?

Share this post


Link to post
Share on other sites
1 minute ago, AngryChris said:

Does it have a drop sensor?  Is it only that selection?  Did you change the motor?

I apologize AngryChris, I am fairly new to vending. I do not believe there is a drop sensor. I did not change the motor. How would I go about doing so?

Share this post


Link to post
Share on other sites

I think you probably have a drop sensor. Try actually vending something. Because there is no real setting to have a spiral turn 3 turns, the only reason it happens is when the sensor doesn’t detect a drop.

You don’t need to switch motors. I think Chris was just asking to make sure you didn’t. Doesn’t matter how many count spirals you have, it’s always gonna be 1 turn per vend. 

  • Like 1

Share this post


Link to post
Share on other sites

If you don't have drop sensors it does sound like you somehow turned on Goldeneye for that selection.  You need to revisit the Goldeneye programming.

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now

×
×
  • Create New...