chris in bc Posted November 18, 2014 Share Posted November 18, 2014 I have a AP 7500 ( work horse). I just installed a Vendors exchange, Universal Control board! Good bye electronic problems! I need to know whether you can install a Bill acceptor on one of these 7500 machines...and which brand? I also have about 60 coinco coin mechs for sale....anybody want them? Link to comment Share on other sites More sharing options...
AZVendor Posted November 18, 2014 Share Posted November 18, 2014 That logic board will support any MDB bill acceptor, but if you still have the original AP7000 door on it then you have to use a MEI because it fits the door properly with Mars brackets. You never sent me a list of what models and quantities of mechs you have, Chris. If you'll do that I can make an offer on them. Link to comment Share on other sites More sharing options...
chris in bc Posted November 18, 2014 Author Share Posted November 18, 2014 So, for a MEI b/a to work you need special brackets for a 7500? Do you sell them randy? Link to comment Share on other sites More sharing options...
AZVendor Posted November 18, 2014 Share Posted November 18, 2014 I have Mars brackets in stock if you need them. If there's never been a validator installed or it was something other than a Mars validator then you will need two brackets and a bill acceptance label for the front of the panel if no validator was there before. Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.