, pub-6262331124919164, DIRECT, f08c47fec0942fa0 Jump to content

Coin mec reading "no credit" when given coins

Recommended Posts

Coinmec was reset to factory settings, now is reading "credit" to quaters and nickles (the denomination is is programmed to hold) .

If i put in a dollar coin or dollar bill ot will give exact change but if I put in a quarter it will shoot straight back out and give no credit.

Link to comment
Share on other sites

Gotta be careful about pressing buttons.  Old coinco mechs were pretty simple to tune; however, I think this unit requires being attached to a programmer.  Check the manual to see if there's a setting to config country and denomination.

Link to comment
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
  • Create New...