Ceez Posted January 6 Share Posted January 6 (edited) Hey everyone, There is an issue with my digital cold control/temperature probe in which the temperature freezes my soda cans. When I set the temperature to 38°F, it sometimes goes as low as 6°F. The digital cold control board and sensor are obsolete parts #(13600001) and I cannot source them anywhere. There is an option to send the board in to get repaired but I'm not sure if this is the best option. Can someone help explain how to bypass my current digital cold control and temp. Probe with this other LCM4 cold control that I bought. P# (D360204). Thanks Edited January 6 by Ceez Link to comment Share on other sites More sharing options...
AZVendor Posted January 6 Share Posted January 6 I've already told you how. If it's beyond your capabilities then you need to find a good vending repair tech who can do this for you. Or scrap the machine or sell it to someone else and make this their problem. Link to comment Share on other sites More sharing options...
Ceez Posted January 6 Author Share Posted January 6 4 hours ago, AZVendor said: I sent the wiring diagram to you, which was very difficult for me to find. And you never replied to me to help any further. The repair tech I hired couldn't help me out either. Link to comment Share on other sites More sharing options...
AZVendor Posted January 7 Share Posted January 7 Check the other thread now. I remember that while I was reading it I had to leave and I never went back to it. Link to comment Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now