ABCVending Posted April 21, 2017 Posted April 21, 2017 Just started going through a bunch of DN 2145/5591's to see what needs attention - so far so good, most of them have the taller gates, everything seems to be working but have a couple that are missing the springs for the pushers - they didn't pop up on Fleabay so thought I'd check here. Are the taller pushers that much of an advantage? Seem expensive for what you get - pretty sure I could zip tie a piece of lath or something to the short pusher to make them taller... In the pile of misc coin mechs, found a couple of the Coinco 9302 GX which I thought was an MDB mech - all the ones I have have the square MDB connectors - this one has a flat connector (picture) - can I cut this off and splice on the regular connector? Or is this for a specific machine?
AZVendor Posted April 22, 2017 Posted April 22, 2017 I have tons of parts for them. If that connector goes straight into a coin mech then someone has monkeyed with. That is not any standard coin mech plug. Email me at rbepic4gatgmaildotcom
Recommended Posts
Archived
This topic is now archived and is closed to further replies.