matthew0582 Posted February 20, 2015 Share Posted February 20, 2015 I want to enable the drop sensors. I need to replace both sensors. The machine was disabled for reasons i dont know. How hard is it to replace and aim these sensors? Link to comment Share on other sites More sharing options...
AZVendor Posted February 20, 2015 Share Posted February 20, 2015 Did you get my PM about that? I explained it pretty well there. Do you want me to send you the sensors or have you figured out what part of the sensor system is disconnected? Link to comment Share on other sites More sharing options...
matthew0582 Posted February 20, 2015 Author Share Posted February 20, 2015 everything is connected correctly but the sensors are disabled for whatever reasons. before i buy new sensors i wanna make sure they are easy to aim, also how do i change the attempt number? Link to comment Share on other sites More sharing options...
Walta Posted February 20, 2015 Share Posted February 20, 2015 Before you buy the sensors test the ones you have. Did you turn on the sensors in the software? Does the LED on the sensor change when you block the beam? Generally the sensors only fail from abuse. Most commonly people see an empty spot in the machine and decide to fill it up with junk. Often they push the sensor out of alignment sometime the cables are damaged. Walta Link to comment Share on other sites More sharing options...
AZVendor Posted February 20, 2015 Share Posted February 20, 2015 The new sensors are real easy to aim because they have the red LED light that shines at the target so you can aim them. Then you have to go into the menu that includes Enable Drop Sensor to turn it on, then go to the menu with Set Retry Limit to set the number of re-trys you will allow. Get the manual and follow the directions in each section for how to do it. Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.