mountain vender Posted October 8, 2017 Share Posted October 8, 2017 One of my chambers on my DN machine had a motor that only went about 1/4 turn. I thought the problem was the motor. Therefore, I swapped out & installed a newly purchased rebuilt motor. Same thing happened, only moved 1/4 of the way. Any suggestions to help me pin point problem is appreciated. Thank you!! Link to comment Share on other sites More sharing options...
AZVendor Posted October 8, 2017 Share Posted October 8, 2017 First of all, there are no "rebuilt" motors as there's no way to do that so I don't know why someone would tell you that. Otherwise, you probably have a bent rotor that is binding on the column's sidewall. Email me the model of machine and I can send you a new rotor for it. rbepic4gatgmaildotcom Link to comment Share on other sites More sharing options...
MikeWinningVendors Posted October 8, 2017 Share Posted October 8, 2017 ^What AZ said. But just in case, did you check your cams? Maybe it's just set to bottles or cans? Link to comment Share on other sites More sharing options...
mountain vender Posted October 8, 2017 Author Share Posted October 8, 2017 Yes, cans, 2 notches....No one told me it was rebuilt, I must be wrong. It was most likely parted out of a machine. What is a bent rotor? Link to comment Share on other sites More sharing options...
AZVendor Posted October 8, 2017 Share Posted October 8, 2017 If this is a narrow column then the rotor is the part that turns in the column holding the cans. Link to comment Share on other sites More sharing options...
mountain vender Posted October 8, 2017 Author Share Posted October 8, 2017 Yes, it is a narrow column. I will check it out tomorrow, thank you! Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.