Kcdivine Posted December 5, 2017 Share Posted December 5, 2017 Can you use a vendstar without screw hold wheel. If not where can I get some? its screw shown in picture Link to comment Share on other sites More sharing options...
NYCandyMaN Posted December 5, 2017 Share Posted December 5, 2017 take a clearer picture, and a few of where it is Link to comment Share on other sites More sharing options...
Kcdivine Posted December 5, 2017 Author Share Posted December 5, 2017 Link to comment Share on other sites More sharing options...
gumball guy Posted December 5, 2017 Share Posted December 5, 2017 You can get the screw at any hardware store. You could probably get away without the screw because the clips in back should hold it but without it the brush off may pop up and cause a jam or misvend. Also when you go to pull the canister out of the machine the whole bottom could come out. I would replace the screw. Link to comment Share on other sites More sharing options...
orsd Posted December 6, 2017 Share Posted December 6, 2017 Also, if the screw hole is damaged/stripped go up a size, it will help it hold better. Link to comment Share on other sites More sharing options...
jerrybrooksvendall Posted December 20, 2017 Share Posted December 20, 2017 Home Depot. You need that screw. Plastic tabs will break. Everything will come out of the bottom and land in the floor. Replace it. Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.