Robcamaro Posted April 3, 2014 Share Posted April 3, 2014 Can someone tell me the best way to remove decals from the side of a soda machine. Does a heat gun work? Thanks. Link to comment Share on other sites More sharing options...
mission vending Posted April 3, 2014 Share Posted April 3, 2014 Heat gun on low setting and a lot of patience, especially if its old and brittle Link to comment Share on other sites More sharing options...
hazenevenson Posted April 3, 2014 Share Posted April 3, 2014 orange oil works well Link to comment Share on other sites More sharing options...
Vendors Tech Posted April 4, 2014 Share Posted April 4, 2014 Yep, heat gun works fine. Most will never come off perfectly though. You'll probably have to sand the side, put on some new paint, and maybe some new decals to make it look good. I rarely get one off without scratching the paint or leaving behind some glue. Link to comment Share on other sites More sharing options...
orsd Posted April 4, 2014 Share Posted April 4, 2014 Another question If the old one is still solid can new graphics just be used to cover the old one? Link to comment Share on other sites More sharing options...
AZVendor Posted April 4, 2014 Share Posted April 4, 2014 It's not advisable to put a new decal over an old one as there can be surface adhesion problems due to grime and holes, cuts or divots in the existing decal that you can't easily see. Link to comment Share on other sites More sharing options...
IVEND11 Posted April 5, 2014 Share Posted April 5, 2014 I use a propain torch just get it hot quick then start pulling. If there is glue left on the machine use mineral spirits wipe it all over it let it stay on the glue for about ten mins then it will wipe off Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.