paulb Posted November 18, 2014 Share Posted November 18, 2014 My bill acceptor will not do anything when in place. When I cycle the on /off switch the unit spins I have been told the board is good what should I look for and is there a wiring diagram Link to comment Share on other sites More sharing options...
Walta Posted November 19, 2014 Share Posted November 19, 2014 I say throw it away! It was a POS in 1990. Get yourself a mar 2501 much better acceptance rate and lower failure rates. Walta Link to comment Share on other sites More sharing options...
AZVendor Posted November 19, 2014 Share Posted November 19, 2014 My bill acceptor will not do anything when in place. When I cycle the on /off switch the unit spins I have been told the board is good what should I look for and is there a wiring diagram Welcome to the forum! You can PM me for a replacement upgrade if you need one. Link to comment Share on other sites More sharing options...
AngryChris Posted November 19, 2014 Share Posted November 19, 2014 If any MAKAs give me any trouble, I replace them. I will say this though... The ONLY reason why I would rather have an old machine with a VFM than a MAKA is because it's a lot easier to upgrade the machine to a 2511 if it has a VFM in it. Now.. if the machine has an old ARDAC contraption that they call a "bill acceptor" then I usually laugh. MAKA's are not nearly as bad as those. Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.