Crane 432 shopper

[TBaanah]

The shopper display shows can't home .l have replaced all 3 board-

Stop solenoid and the torrent motor 

[Technivend]

Does the turret try to move and try to home? 

I'm pretty sure they used the magnetic home sensor on the 432 like on the 431. So I would look at the edge of the turret by the gear and there should be a magnet somewhere along the perimeter. If you find the magnet then check the magnetic switch.

[TBaanah]

14 hours ago, Technivend said:

Does the turret try to move and try to home? 

I'm pretty sure they used the magnetic home sensor on the 432 like on the 431. So I would look at the edge of the turret by the gear and there should be a magnet somewhere along the perimeter. If you find the magnet then check the magnetic switch.

I found one magnet and  tested the magnetic switch .it is responding.

[Paul O Leary]

Hi try replace the grey ribbon cable that comes from the  control board down to the interface board also the door switch.

[AngryChris]

5 hours ago, Paul O Leary said:

Hi try replace the grey ribbon cable that comes from the  control board down to the interface board also the door switch.

Hi Paul, this post is 4 years old and I am sure they got it resolved by now.

[AZVendor]

Lolololol. Is that how I burst into laughter at someone thinking a 4 year old post needed an answer?  Some people.....