help Posted April 22 Share Posted April 22 I'm wondering if someone can't point me in the direction of diagnosing issues with a 213 coffee mch not dispensing small cups. I checked the obvious. Cups are full and no jams. Large cups dispense fine. What are the most common causes of this type of issue and where best is it to start diagnosing? Thanks Link to comment Share on other sites More sharing options...
cvending Posted April 22 Share Posted April 22 Does it try to dispense the cup? Does the cup motor run at all? Was it working previously? Link to comment Share on other sites More sharing options...
Vendo Mike Posted April 22 Share Posted April 22 I think the AP213 had a separate test to operate the cup solenoid. Is there an error when it doesn't dispense? Link to comment Share on other sites More sharing options...
AZVendor Posted April 22 Share Posted April 22 There is a cup drop test to see if the motor moves. They usually do and I've never seen a cup motor go bad but they are about 25 years old now. Otherwise, cup drop problems are due to incorrectly sized cups or rather, incorrectly set cup rings. These cup rings can't be stocked willy nilly with just any cup you choose to put in it. The cup ring always has to match the cup you use so you should always buy the same cups each time to avoid problems. To adjust the cup ring you will loosen the adjustment lever on the outside of the ring and put just one cup into the ring. You want to adjust the ring so that the white cup pawls extend into the ring just far enough to hold the rim of the cup but not so tight that the cup is held tight in the ring. Once it's adjusted then test the cup by pulling on it a bit to see if it falls out or can easily be pulled out from below. If so then adjust it just a bit tighter so that the cup moves and spins but isn't tight in the ring. Then lock the ring adjuster down and put a short stack in to test through the test function. If the cups don't drop then adjust the ring again. You also need to make sure the rims of any cups aren't damaged. If they are then throw them away. Link to comment Share on other sites More sharing options...
cvending Posted April 22 Share Posted April 22 My earlier post was to determine if the cup empty switch was being held closed. If it thinks it is out of cups it will not vend that size cup. Link to comment Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now