dewser Posted April 21, 2019 Share Posted April 21, 2019 on my digital display I am getting Rs on the screen not the normal display.Is this fixable with some kind of reset or is the display board shot Link to comment Share on other sites More sharing options...
dewser Posted April 21, 2019 Author Share Posted April 21, 2019 Link to comment Share on other sites More sharing options...
cvending Posted April 21, 2019 Share Posted April 21, 2019 Try unplugging the harness from the control board first and reinserting it securely. If that does not work try unplugging harness from the display board and RTI seeing Link to comment Share on other sites More sharing options...
dewser Posted April 25, 2019 Author Share Posted April 25, 2019 ok.i will give it a shot.should the machine be on or off Link to comment Share on other sites More sharing options...
cvending Posted April 25, 2019 Share Posted April 25, 2019 machines should always be off when connecting or disconnecting harnesses. Link to comment Share on other sites More sharing options...
dewser Posted April 25, 2019 Author Share Posted April 25, 2019 Thank you very much.i will try it in the morning.Just to make sure im clear unplug it from the S11D board Link to comment Share on other sites More sharing options...
dewser Posted April 25, 2019 Author Share Posted April 25, 2019 I did what you said and it showed 1 R not all the way across Link to comment Share on other sites More sharing options...
AZVendor Posted April 26, 2019 Share Posted April 26, 2019 You likely need a new display board. Link to comment Share on other sites More sharing options...
dewser Posted April 26, 2019 Author Share Posted April 26, 2019 I was hoping that wasn't it but I think your right.Thanks again Link to comment Share on other sites More sharing options...
dewser Posted May 7, 2019 Author Share Posted May 7, 2019 how many coins should be in the coin mech for the machine to work Link to comment Share on other sites More sharing options...
AngryChris Posted May 7, 2019 Share Posted May 7, 2019 If the mech is working properly then you only need maybe $2 worth of any denomination to satisfy the exact change condition. Is that what you are asking about? Link to comment Share on other sites More sharing options...
dewser Posted May 7, 2019 Author Share Posted May 7, 2019 yes,i wasn't sure if each denomination had to have so much in each slot Link to comment Share on other sites More sharing options...
dewser Posted May 7, 2019 Author Share Posted May 7, 2019 is there a fuse any where on this machine Link to comment Share on other sites More sharing options...
AZVendor Posted May 7, 2019 Share Posted May 7, 2019 10-15 coins in each slot should work but you will need to use the Tube Fill mode if you have an MDB coin mech. Why not fill the tubes? Link to comment Share on other sites More sharing options...
AZVendor Posted May 7, 2019 Share Posted May 7, 2019 The fuse is on the logic board, but a bad display won't be caused by a fuse. Just replace the board and see if that fixes it. It's the easiest part to get even though I suspect it's a bad display. The problem with displays is that you could have any of about 6 different ones depending on your machine's vintage. Link to comment Share on other sites More sharing options...
dewser Posted May 7, 2019 Author Share Posted May 7, 2019 ok,thanks.Im wanting to sell it without putting a lot of money into it Link to comment Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now