vxl65703 Posted March 8, 2022 Share Posted March 8, 2022 I have a 501E that is not getting power to Bill Validator, Coin Mech, LED, button selector Etc. door lights come one and it cools. I changed the control board out but that didn’t wor, any ideas ? Link to comment Share on other sites More sharing options...
orsd Posted March 8, 2022 Share Posted March 8, 2022 Make sure the barrel shaped plug near the hinge area around the bottom of the machine didn’t get unplugged. Link to comment Share on other sites More sharing options...
AZVendor Posted March 8, 2022 Share Posted March 8, 2022 With power to the lights and control board the barrel plug is connected. It sounds like a blown fuse on the logic board. 1 Link to comment Share on other sites More sharing options...
vxl65703 Posted March 11, 2022 Author Share Posted March 11, 2022 Do you have a diagram as to where the barrel plug is located? Link to comment Share on other sites More sharing options...
AZVendor Posted March 11, 2022 Share Posted March 11, 2022 Lower left corner of the cabinet. 1 Link to comment Share on other sites More sharing options...
Popular Post Vendo Mike Posted March 11, 2022 Popular Post Share Posted March 11, 2022 If you have a shorted board or payment system and you "swapped the board", you will have blown the same fuse in the new board and find yourself back at square 1. Kill power to the machine and pull the cover from the board. You'll find a group of 3 fuses that need to be checked. If you find a blown fuse, you'll need to double check that circuit and replace the shorted component (coin, dbv ) along with the fuse on the board.. 2 Link to comment Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now